After more than a year of sourcing the best parts from around the country, this was our first complete shop kart with all our own parts.
We start our rollers with a Steven Gannon Racing chassis. Designed and built by a kart racer for kart racers, this is the finest chassis on the market today.
Ultrashield race seats, Crow or Pyrotect harness, Joe’s Racing steering wheel and quick release, MCP rear brake and Hegar4 front brake, braided lines
Gannon wing, Solomon wing rails, XTreme wing T and center pull system. We use Primo Powdercoating and Ratt Graphics on all shop karts.
Xtreme hoods and tails are built to look good and last. Hand-laid fiberglass, reinforced in the right places, does not need paint to look good.
WJoe’s lightweight steering wheel and quick release hub, ¾ inch shaft connected with heims top and bottom, hex or moly tie rods, XTreme kingpins, spindles, and blocks.
Box stock rollers use 1-1/8 inch chassis (shorty available), Ultrashield junior total support seat, 2-inch harness, no beadlocks, no front brake, no wing slider.
Open rollers come with Xtreme XTR4 beadlocks.